For Buckmaster's HAMCALL, type D:\ham0\.How to set callbook database path in Callbook Settings dialog? Several interfaces require RST=Always On or DTR=Always On. Refer to interface manual and set RST and DTR state properly (CAT/RCP dialog, port details, don't forget to set RS232 baudrate, etc.).Set Spectrum speed (See soundcard settings) to higher value (x4 is OK).Turn off average spectrum line (if not in waterfall mode).Set DSP filter to none (See soundcard settings). Set samplerate to 8000 (See soundcard settings).Set spectrum speed to Slow (See soundcard settings).To get rid of docked tool bars, drag them out of MixW window, or double-click with left mouse button, or drag with CONTROL or SHIFT key pressed.I have gray space under tool bars is too large. When I executed the downloaded file, all when well until a window popped up during installation stating, "Error starting program The CREATEMIXW2SHORTCUTS.EXE file is linked to missing export SHEL元2DLLSHGetSpecialFolderPathA"įollowing this notice, another window displayed, "Error Executing the Specified Program D:\Program Files\MixW2\CreateMixW2Shortcuts.Exe".(P III 730 Mhz w/ 256 k RAM) I would like to see the detail at 8X. I have found that running spectrum speed at 4x and above seems to swamp my processor and bring the program to a grinding halt.What is to be done to have a shorter delay between TX and RX in FSK mode?.Where can I find specific macros: "OnStartMixW", "OnEndMixW", "OnOpen.", "OnClose.", "Gray." etc?.When listening/reading only, the frequency is stable, but when receiving just upon my transmission the reading is garbled and the indicator has to be adjusted a few Hertz lower.I can't setup the PTT option, because have to set it each time the program is loaded to work, the message was posted about it.How can I use mixw and ui-view with my SOUNDCARD ?.At the low end of the Waterfall display I have at a zero audio frequency two yellow bars close together.Whether uses MixW the Registry of Windows? And how to delete the program MixW from the computer?.How can I start another program just by opening MixW?.Is it possible to run two instances of MixW?.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |